-13%
HPI SF-50WP SERVO (WATERPROOF/12.0KG-CM6.0V)

HPI SF-50WP SERVO (WATERPROOF/12.0KG-CM6.0V)

65,00€ 75,00€
Brands Hpi racing
Product Code: 0632
Availability: In Stock

This extremely powerful, waterproof servo is ideal for pedestrians and runners looking for an extremely hard and extremely durable servo for absolutely any type of situation. Use this on your truck, buggy, tour car, monster truck - any kit that requires a full-size servo to handle whatever you can drive!




Basic Futaba 'J' socket, with impressive specification:


Speed: 0.18 sec / 60 degrees (at 6V)


Torque: 12kg-cm at 6V


Waterproof


25 serrated wedge


NOTE: Before driving in wet conditions, make sure that all the electronics installed in the vehicle are safe to use (designated as water resistant or waterproof) or that they are fully enclosed and protected from water and moisture (as in a sealed receiver). battery case). Fans mounted on speed controllers are not water resistant - we recommend disconnecting the fan from the ESC before driving in wet conditions and letting it dry completely before reconnecting the fan power. Lubricate exposed metal drive components such as bearings, outboards and differential shafts before driving in wet conditions. Engines are not intended for submersible use and may be damaged when used underwater. After driving in wet conditions, be sure to rinse dirt and corrosive liquids such as salt water with clean water and lubricate the metal drill again.



This extra-strong, waterproof servo is ideal for bashers and racers looking for a super-tough and extra-durable servo for absolutely any kind of condition. Use this in your truck, buggy, touring car, monster truck - any kit that requires a standard-size servo to handle whatever you can drive through!


Standard Futaba 'J' connector, with impressive spec:

Speed: 0.18 sec / 60 degrees (at 6V)

Torque: 12kg-cm at 6V

Waterproof

25 tooth spline


 

NOTE: Before driving in wet conditions, make sure that all electronics fitted to the vehicle are safe to use (marked as water-resistant or waterproof), or that they are fully enclosed and protected from water and moisture (such as in a sealed receiver / battery case). Fans mounted on speed controllers are not water resistant - we recommend to disconnect the fan from the ESC before driving in wet conditions and allow it to dry completely before reconnecting the fan power. Lubricate exposed metal drivetrain parts such as bearings, outdrives and diff shafts before driving in wet conditions. Motors are not intended for submerged use and may be damaged if used when under water. After driving in wet conditions, make sure to rinse off dirt and any corrosive liquids like saltwater with plain water and re-lubricate metal drivetrain parts.

Write a review

Note: HTML is not translated!
    Bad           Good